In this video, we revisit the concept of the guide point offset and how to reset the guide point using the SCU6x Controller. This technique is particularly useful when working with wide sensors and handling the web at different positions. The video walks through the steps of resetting the guide point, both in automatic and manual modes, ensuring precise guidance of the web. By following these instructions, you can maintain the correct positioning and handling of your web material, helping to enhance operational efficiency and accuracy.
00:00 Introduction to Guide Point Offset
00:25 Resetting the Guide Point
00:29 Automatic and Manual Guide Point Adjustment
01:06 Conclusion and Summary
Transcript
Show full transcript (179 words)
okay in our previous video we looked at the guide point offset basically how to reset the G Point again that is useful when you have a white sensor and you uh present the web like different locations so just to go over that one more time here I've got a white sensor here and the web is positioned at some point I'm going to go in and reset great Point except up there and if I put the we p in automatic it's going to stay in that position and if I need to change that date point to a new location when it's in manual and we can still do that the web isit this new location and I'm going to do the reset cway accept and when I put it in Auto in SC the actuator is staying in position because the web is at the point location and if I move the web to one side part the other it's little stop it's going to die with respect to that and that's the re cway