Demos

How to Set the Actuator Parameters in SCU5 Controller

This video shows how to set the actuator parameters on the SCU5 controller. 

Since Roll-2-Roll Technologies offers several different actuators from different vendors, this allows for lot of flexibility for the end customer. 

👉🏻 More information on the actuator are here: 🔗https://r2r.tech/products/roll-2-roll-actuators For more information about the SCU5 controller please visit: https://r2r.tech/products/roll-2-roll-controller.

How to setup Web Width Measurement based on Web Edge with SCU5 Controller using Two Sensors

For a complete overview of web width measurement with Roll-2-Roll® Sensors and Roll-2-Roll® Controller please visit this page: https://r2r.tech/articles/web-width-measurement-and-monitoring-applications-and-technology

 

For more information about the SCU controller please visit: https://r2r.tech/products/roll-2-roll-controller

How to Add SCU5 Controller with EtherCAT to Beckhoff PLC using TwinCAT

This video shows how to import SCU5 controller as a device into EtherCAT with the ECS file.

👉🏻 EtherCAT ECS File for SCU5 firmware Version 3.5+ using Hilscher Module:

🔗https://r2r.tech/documentation/ethercat-ecs-file-scu5-firmware-version-35-using-hilscher-module

For more information about the SCU5 controller please visit: https://r2r.tech/products/roll-2-roll-controller.

Setting the Parameters of SCU5 for Servo Center Operation using a Physical or Electronic Position.

 

How to set the servo center position or the home position using the SCU5 controller.

  • 1: 22 Physically installating a proximity sensor to detect the home position.
  • 4:32 Changing the polarity of the servo center sensor.
  • 5:39 Some common problems with servo center or proximity sensor installation.
  • 7:00 Servo center position based on the electronic actuator position.
  • 8:30 Setting the servo center position electronically.
Subscribe to Demos