Standard Operating Procedure - Center Guiding Application (v3.x)
1.0 MBThis document provide the standard operating procedure for the simple center guiding application. This can be printed, laminated and displayed next to the web guide for easy training to new operators.
Document Text
Show document text (169 words)
1110 S Innovation Way Dr Standard Operating Procedure Stillwater, OK 74074 Center Guiding Application E: sales@r2r.tech W: https://r2r.tech P/F: +1-888-290-3215
During a product changeover or after a width change the following settings can be followed to startup the web guide. Step 1: If the web guide is in Automatic mode switch it to manual mode as shown below.
Step 2: Servo center the web guide.
Step 3: If needed position/thread the web at the desired location on the rollers. Step 4: Position the two sensors so that web is approximately in the middle of the sensing window of each sensor.
Step 5: On the SCU5 operator interface ensure that the two edges are seen by the controller and reset the guide point.
Step 6: Press the Automatic/manual button to put the web guide in Automatic Mode.
Step 7: If needed use the fine guide point adjustment to fine tune the desired web location.
All Right Reserved. Copyright © 2019 Roll-2-Roll Technologies LLC. Content subject to change without notice.