position sensor

one of our features and our sensor and controllers setups that we have is the automatic guide point adjustment which makes it easier to set up your converting line by just putting the material on your sensor and then once you have the material at the position you want you can just by pressing a button reset the guide point whatever you want so let me show you how it works in this case we have it set up for senator guiding right and as you can see as I move the material around you can see where the material position is at and you can see the center of the material with that green line but however on the top part of the screen or that bar you can see a gray bar that is our actual guide point right now but if I want to reset it to say this position right here all I have to do is just press the reset guide point button and then as soon as I hit accept it will automatically take it to that position so now I have reset my guide point for this operation now this can be used for edge Center guiding with one or two sensors or contrast guiding this is beneficial for people who have operations where they move the material quite often where in in their converting line and therefore do not want to have the hassle of just doing a precise reset of their guide point it's a very easy setup very easy operation and it will save a lot of time for you in your converting line you

hello this is Pedro Velasco withdrawal to all technologies we had some customer feedback on our sensor mountings and we did some some research and then we created a new sensor mounting that you can easily put on your operation so for example for 221 sensor as you can see our we have our typical sensor mounting which is as brackets that we ship our sensors with but additionally to that we just found these off the shelf brackets that we can mount on a one inch square bar in this case it's a extrusion and it fits perfectly this so it allows you to with a quick release just to be able to move your sensor around really easy right so you can just light it through and then once you use your quick release and just tighten it back up it provides a very very sound fixture so these has pretty good for those operations what we're doing retrofit kits on new hydraulic systems and people want to have the sensors mounted on the existing bar or they can just acquire a new aluminum extrusion bar or one-inch extrusion bar and they can just mount this now this is off the shelf so it's a very easy to to access and we can provide it for you or we can tell you where you can buy these so that you can do a very sound mounting of our 2:21 sensor on your retrofit kit for replacing pneumo hydraulics so you can see more of this at our website on wwr to our Tec h so it's you